1UZ LOG EXHAUST MANIFODS

After running into some clearance issues with our 1UZ to Z20 Soarer swap it became pretty apparent that we were going to be limited to using log style manifolds and figured others may be in the same boat. We have since decided to do a small run of some standard logs and some extra tight ‘block hugger’ style manifolds if you have absolutely minimal room to move.

The manifolds will be made from 3.6mm wall section SCH40 pipe and bends and painted with high temp paint to help prevent corrosion. No flange will be fitted as these can be either used as a base for a turbo setup or routed with additional bends to suit your install .

Share this post

One reply on “1UZ LOG EXHAUST MANIFODS

Leave a Reply

Your email address will not be published. Required fields are marked *

ELATE MFG. – Est. 2014 – Geelong, Australia