ELT X HLY EFI PLENUM MANIFOLD *SCRATCH & DENT*
** DUE TO A HANDLING ISSUE WE HAVE A COUPLE UNITS THAT HAVE SUFFERED SOME DENTS AND SCRATCHES DURING TRANSIT AND SO ARE BEING OFFERED AT A DISCOUNTED RATE. THE DAMAGE DOES NOT EFFECT THE MANIFOLDS ABILITY TO DO AS INTENDED AND IN ALL CASES THE DAMAGE CANNOT BE SEEN ONCE ASSEMBLED. THESE UNITS ARE SOLD WITH ALL HARDWARE AS SHOWN BELOW**
If you’re building a 1UZ-FE turbo setup and looking for a front facing manifold then this may be an option for you.
This billet aluminium manifold adapts the readily available cast Holley EFI plenum to the factory 1UZ lower intake manifold whist positioning it in just the right spot to clear the engines water crossover pipe along with the fitting located on top of the thermostat housing.
The total stack including the Holley EFI plenum is approx 149.5mm from the mounting face of the lower intake manifold.
Designed to suit Holley P/N 300-209
- 12 x M8 countersunk fasteners
- 12 x M6 cap screws
- 1 x O-ring seal
** Note that this cannot be used with a straight thermostat housing for clearance issues.
or 4 payments of AUD$195.00 with
Only 1 left in stock