I often get asked what parts do I require when piecing together a supercharger kit so figures I’d get this post together as a bit of a guideline. I’ve listed all the key items however there may be other items like clamps, hoses , etc. that have been left off.
I have marked items with a * if used in an intercooled setup only.
- ELATE intercooled* OR non-intercooled supercharger manifold w/ top plate to suit your chosen supercharger.
- Runner extenders for “Toyota air injection system” clearance (Some 2UZ engines ONLY).
- Supercharger with functioning bypass.
- 2UZ fuel rail adapter kit (2UZ VVTI Engines only)
- Throttle body extension loom (6 pin version only)
- OEM intake gaskets (pair) (2UZ VVTI Engines with plastic intake manifold only)
- Dual pass external heat exchanger with -12AN fittings
- Correctly sized supercharger pulley
- Drive belt (measure once installed)
- ELATE throttle body adapter to suit supercharger and throttle body being used.
- Intake tube between throttle body and airbox will need to be fabricated. Silicone joiners and hose clamps will also be needed.
- Smooth idler pulley
- 400 series or other -12AN hose *
- 2 x -12AN 90 hose ends to suit hose used. *
- Bosch 1200LPH W2A pump or similar *
- ELATE W2A pump relay loom (Suit mini fuse) *
- ELATE W2A reservoir w/ 15psi relief cap *
- Water pump mount *
- ELATE fuel rail line kit (engine specific)
- Rising rate fuel pressure regulator (2UZ Engines or engines with external regulators recommended)
